Cisco Configure replace
Have you ever made some changes to a Cisco router and needed to revert back to the start-up config?
Well, it is alot easier now, as you know the "copy start Run" wont do it, that merges the two to make some monster of a config. The command is "configure replace" and will replace the running config just as if you had re-booted a router.
I have not tried this myself I am assuming that this will have some impact in a production environment? Any how the article says that this is part of a feature known as Configuration Rollback.
Here is the link, check it out.
Well, it is alot easier now, as you know the "copy start Run" wont do it, that merges the two to make some monster of a config. The command is "configure replace" and will replace the running config just as if you had re-booted a router.
I have not tried this myself I am assuming that this will have some impact in a production environment? Any how the article says that this is part of a feature known as Configuration Rollback.
Here is the link, check it out.
www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide09186a0080356ea5.html
